The Mitsubishi L300 is a great versatile van, whether you’re a Tradie, freedom camper or its your daily driver. There is one issue though… Not a single cup holder in sight! Considering these vans were produced all the way to 2015, What was Mitsubishi thinking??
Anyways, Modern (ish) problems require modern solutions. This here is a NZ designed and made cup holder made from durable, UV resistant ASA plastic. The smart design means it can be installed in under a minute by anyone with a screwdriver. Available in 2 variants, The straight up cup holder, Or the cup holder with a “pouch” on the front for phone/wallet storage ( no more sliding off the bench seat around sharp corners)
Installation is as simple as:
Remove one Phillips screw from the shifter surround
Push back the rubber shift boot, then hook over the top tab of the cupholder
Using the holes in the front for access, Re install screw
The Mitsubishi L300 is a great versatile van, whether you’re a Tradie, freedom camper or its your daily driver. There is one issue though… Not a single cup holder in sight! Considering these vans were produced all the way to 2015, What was Mitsubishi thinking??
Anyways, Modern (ish) problems require modern solutions. This here is a NZ designed and made cup holder made from durable, UV resistant ASA plastic. The smart design means it can be installed in under a minute by anyone with a screwdriver. Available in 2 variants, The straight up cup holder, Or the cup holder with a “pouch” on the front for phone/wallet storage ( no more sliding off the bench seat around sharp corners)
Installation is as simple as:
Remove one Phillips screw from the shifter surround
Push back the rubber shift boot, then hook over the top tab of the cupholder
Using the holes in the front for access, Re install screw